A 33-year-old man died while repairing a vehicle in a San Antonio, Texas, driveway on October 28, according to KSAT’s reporting. A jack supporting the vehicle collapsed, and the vehicle fell onto him.
A local repair-shop owner interviewed by KSAT described a close call beneath a truck. “My guy was turning the wheel and the truck just went down,” he recalled.
For anyone working beneath a vehicle, the Health and Safety Executive, Britain’s workplace safety regulator, warns against relying on a jack alone. The vehicle needs proper support before anyone gets underneath, with precautions to keep it from rolling or slipping off that support.
Start with the ground. HSE guidance calls for a hard, level surface, such as concrete, and warns against lifting on a slope. Securely chock the wheels that remain on the ground so the vehicle cannot roll.
Before Going Under
Embedded media follows; please allow a moment for it to load.
Check the vehicle manufacturer’s instructions for both lifting and support points. Use equipment rated for the load, and follow the instructions for the particular jack and stands.
With stands in place, lower the vehicle onto them before work begins. In its Daytona jack-stand instructions, Harbor Freight requires the load to be centered on the saddles and the locking devices fully engaged. It also warns that dropping a vehicle onto the stands can cause them to fail, even when the vehicle is below their rated capacity.
Inspect the hardware before every use, and discard stands with cracks, bends, or other deformation, even minor damage. Check vehicle stability before getting underneath; if the vehicle is unstable, raise it and reposition the stands.
Even at Work
Professional mechanics have died with stands beneath their vehicles, too. A New York State fatality investigation examined the death of a 52-year-old town highway mechanic in October 2020 while changing a truck’s air-brake canisters. The truck fell off a jack stand; its transmission was in neutral, its wheels were not chocked, and it had no additional support beyond a single 12-ton stand.
In a separate California investigation, a 48-year-old mechanic died during a bus brake job in May 1999. The bus slipped off locally fabricated stands positioned beneath its rear suspension, and the front tires had not been chocked. The investigation recommended tested, certified, and rated equipment, wheel chocks, and placing stands on fixed parts of the vehicle.
Equipment recalls deserve a check as well. Harbor Freight’s recall notice identifies certain Pittsburgh Automotive stands that could suddenly drop under load. It directs owners of items 56371, 56373, 61196, and 61197 to stop using them immediately and return them to a Harbor Freight store.
